prefect
Home Engineering Audio Biking Publications Photo Gallery Personal Info
DACS: Microcontroller Module
 
  next up previous contents
Next: Inter-Module Specifications Up: Mixer Unit Previous: Audio Output Module   Contents

Microcontroller Module

For the prototype, a pre-made Motorola 8MHz MC68HC11 microcontroller board will act as the embedded controller for the mixer unit. This board contains an RS232 port, an RS485/RS422 port, an 8-input A/D converter, and an 8255-based peripherial I/O controller. In addition, it includes an I/O port, address decoding logic, and contrast adjustment for liquid crystal displays. Figure 26 shows this microcontroller board.

Figure 26: Axiom CMD-11A8 single-board computer, used in the mixer unit.
\begin{figure}
\psfig{file=hw/cmd-11a8.ps}
\end{figure}

In a marketed model, a custom microcontroller board would be developed that includes only the necessary features. However, due to the time frame of this project, it makes sense to use a pre-manufactured microcontroller board. While it would certainly have been possible to develop a microcontroller board, the time spent debugging the inevitable problems would have significantly taken away from firmware and software development.

Steve Richardson 2000-07-06
Table of Contents

[PDF] [Whole document in PDF 1.9MB]

[more photos and information]

 
Page last modified:
Copyright © 1993-2000 prefect - All Rights Reserved.